Automotive diagnostic & Analysis system

Automotive diagnostic & Analysis system Step by step cara menganalisa kode kerusakan mobil DTC : P code(Powertraint) B code(Body) C code(Casis) U code(Network), No Response from module

DTC Diagnosis P code (Powertraint), B code (Body), C code (Casis), U code (Network), No response from Module and Loss of communication.

04/03/2019

Jual Filter AC Jeep Wrangler JK 2011-2015 Rubicon Sahara Sport 55111302AA ,Filter AC dengan harga Rp 198.000 dari toko online sentral part, Kab. Bogor. Cari product Spare Part Mobil Lainnya lainya di Tokopedia. Jual beli online aman dan nyaman hanya di Tokopedia.

04/11/2018

P2072 code - This diagnostic runs continuosly when the following conditions are met with the engine on, ambient temperature below 7°C (44.6°F). The PCM determines that the throttle plate is stuck. Throttle plate goes through a de-icing procedure. If the throttle blade still doesn't move fault sets...

04/11/2018

Guide diagnostic DTC P code (Powertraint),B code (Body),C code (Casis),U code (Network),on the all Module : PCM,TCM,ABS ESP/ESC,SRS,BCM,TPM,WCM,etc.

04/11/2018

Guide diagnostic DTC P code (Powertraint),B code (Body),C code (Casis),U code (Network),on the all Module : PCM,TCM,ABS ESP/ESC,SRS,BCM,TPM,WCM,etc.

04/11/2018

P2101 code - When the error between the actual position and the desired position of the ETC motor driver, based on the rate change, exceeds a calibrated threshold for one second. Default actions the ETC light flash and the MIL light illuminate.

04/11/2018

P2110 code - When the Powertrain Control Module (PCM) requests to limit engine speed and ETC PWM is too high for 1.2 seconds and before P2118 sets. Default actions the MIL light illuminate, the ETC ligh illuminate.

04/11/2018

P2107, P2111, P2112 Diagnose and repair any other DTCs set in the PCM before proceeding with this test. An intermittent loss of power to the PCM without performing an ETC relearn procedure may cause this DTC to set. Turn the ignition on, with the scan tool read DTCs and record on the repair order.

04/11/2018

This DTC is set when the APP sensor values are learned in-plant but do not reach the minimum or maximum voltage range. Diagnose any APP sensor out of range and 5-volt supply DTCs before continuing.

04/11/2018

P2118 code - The Powertrain Control Module (PCM) detects that the ETC motor driver duty cycle is over 80% for more than five seconds. Default actions the MIL light illuminate, the ETC light flash, if the PWM stays above 80%, P2110 will set first , and if the fault persists P2118 will follow. Root ca...

04/11/2018

P2122, P2127 code - The Electronic Throttle Control (ETC) system uses two Accelerator Pedal Position (APP) Sensors to monitor the accelerator pedal position. The APP sensors 1 and 2 are integrated into one assembly located at the pedal assembly.

04/11/2018

P2123, 2128 code - The Powertrain Control Module (PCM) detects that the correlation between APP sensor 1 and APP sensor 2 is not plausible. Diagnose and repar any system voltage or sensor supply voltage DTCs before continuing with this test. Turn the ignition on with the scan tool, read DTCs and rec...

04/11/2018

P2135 code - The Powertrain Control Module (PCM) determines that the TPS 1 and TPS 2 signals are not coherant. Default action this code the ETC light illuminate, the MIL light illuminate.

Address

Bogor
16161

Telephone

+62 838-9689-9358

Website

Alerts

Be the first to know and let us send you an email when Automotive diagnostic & Analysis system posts news and promotions. Your email address will not be used for any other purpose, and you can unsubscribe at any time.

Shortcuts

Share